Carpet can make a room feel warmer. Here I am sharing you the steps for installation carpet gripper: • First, Measure the location where your carpet gripper will be located. You should take each measurement at least twice. If the location is wide, you should have someone help you in order to ensure complete accuracy. • You have to make a very small mark in the underside of the carpet gripper where your mark is. Adjust the location of your mark as necessary and make your cut very carefully so as not to split or otherwise damage your carpet gripper. • You have to use the proper type of nails to secure it to the floor. You should use one nail for every four to eight inches. Make sure the angled tacks are pointed back towards the carpeted room so they will grip the carpet. • Using the carpet or utility knife, cut the carpet one quarter of an inch from the edge of the carpet gripper. • Discard the cut off piece of carpet. Pull the edge of the carpet away from the carpet gripper. Apply a small bead of seam sealer against the edge of the carpet gripper. Use a carpet tuck tool to make sure the carpet is properly tucked into the carpet gripper.